This pattern can be used for stripers, pike, salmon, steelhead or ocean fish, depending on size. These directions are appropriate for stripers. Use a fast sinking line and rapid long strips. The overall length of the fly should be about 3 inches, which will turn upside down when finished.
HOOK: Mustad 34007 , size 1 to 1/0. Crimp barb.
THREAD: White flat waxed nylon. Attach behind eye. Touching wraps to mid shank then forward to one and a half eye lengths behind eye.
UPPER BODY: Red or white bucktail. (recently, a copper tan color has worked well). Cut a clump from hide about the size of a wooden match stick. Pull out long fibers from tips and line them up with others. Cut bucktail ends at an angle two and three-quarter inches from tips. Attached to top of shank behind barbells, then back to mid Shank. Repeat with a second plump. Apply glue.
MID BODY: Mega Baitfish Emulator pearl color. Cut about 1/8 inch of binding. Attached strands behind barbells to top of shank. Trim to length of fly.
LATERAL LINE: Grizzly neck hackle. Select Two feathers, barbs equal to 1/2 hook gap. cut about 10 barbs short on each side of the butt end of stem, forming a “ crew cut”. Tie in “ crew cut “ on each side of shank behind barbells.
LOWER BODY: white bucktail. Repeat like upper body only use one clump.
THORAX: Red chenille. Strip fuzz from end exposing about 1/4 inch of threads. Tie in infront of body materials. Advanced thread to barbells. Wrap chenille forward. Tie off, cut excess.
HACKLE: Very webby grizzly hackle with pliable barbs. NOTE: picture of fly did not have pliable barbs and too long. Select feather, barbs equal to one and a half hook gap. Cut off fuzz and and prepare crew cut. With dark side up, tip to rear, tie in crew cut between barbells on top of chenille. Stroke barbs to rear while wrapping three times behind barbells.Tie off cut access. Moisten fingers, hold barbs back, make a couple of thread wraps to hold them toward rear.
HEAD THREAD: Make a number of figure 8 wraps around barbells. Form a small tapered nose in front of eyes. Whip finish, cut thread. Apply glue to nose and thread between barbells.
Posted on September 17th, 2025